Roof Install Prep Page - Arrow NP10867 Owner's Manual & Assembly Manual

Roof Install Prep Page

Use the information on this page to complete steps 13 thru 15.
If Roof Beam holes do not line up with Roof
Panel holes, shift the building from left to right. If
this does not help, your building may not be level.
Shim the corners until holes line up.
Measure the building diagonally again to make
sure the building is square. The building should
be square at the base and at the top. This will
make roof panels fi t better and holes will better
align.
If a Roof Strengthening Kit was purchased,
assemble and install before attaching Roof
Panels.
Be sure to carefully follow the Roof Panel
Placement Order Diagram on this page.
The building is square when diagonal measurements are equal.
Roof Panel Placement Order
2
8469
6
7483
8
6529
10
7483
4
8468
Crimped Rib
Whenever a crimped rib and an uncrimped rib meet,
place the crimped rib UNDER the uncrimped rib.
1
5
7
9
3
FRONT
33
Uncrimped Rib
8468
7483
6529
7483
8469
33BH