Corners - Arrow NP10867 Owner's Manual & Assembly Manual

Step 6: Corners
You will need for this page:
(QTY: 8) (QTY: 4)
Place washers on all bolts and screws used on painted parts.
1 Position Front and Rear Wall Panels so
that they overlap the narrow side of the
Corner Panels as shown.
2 Secure Panels with a screw in the top
and bottom of each Panel. Insert a bolt
and nut through the middle hole of each
Panel.
9374
Connect Front Wall Panels (9374) to Corner Panels with one (1)
screw in top and bottom holes and one (1) bolt in middle hole.
Always double check that the correct Wall Panel
is installed in the correct location by confi rming
the part number in the manual with the part
number inked on the Panel. Panels look similar
and could be easily mistaken.
2
6627
Wall Panel
6627
Connect Wall Panels (6627) to Corner Panels with one (1)
screw in top and bottom holes and one (1) bolt in middle hole.
FRONT
22
2
9374
8471
Corner Panel
Wall Panel
The best way to assemble the Corners is on a fl at,
elevated surface such as a table or workbench.
If one of these is not available to you, you can
support the Corner Panel and Wall Panel on the
carton your shed was shipped in. Position the
Panels as shown and insert screws.
9374
4
6627
22BH