Enrolling A Detector With A Panel - Interlogix SDX-135Z User Manual

10. Enrolling A Detector With A panel

The following section provides a general guideline for programming (enrolling) the detector into control
panel memory. Refer to the panel documentation for complete programming details. This model requires
enrolling with a panel as two (2) separate devices.
1. Set the control panel to the installer programming mode
2. When requested to broadcast a signal from the detector to the panel, remove the detector from the
mounting bracket (trim plate). A tamper message will be transmitted for smoke and freeze devices.
3. After waiting approximately 1 minute, reinstall the detector on the mounting bracket (trim plate). The
detector will start chirping once every 30 seconds if not re-installed on the trim plate after 3 minutes.
4. Exit installer programming mode on the panel.
NOTE: Each enrollment type (smoke, Freeze) is programmed with a unique TX ID when manufactured.
Labels included on the outside and inside of the packaging provide these IDs. The unique ID is enrolled
into the control panel at the time of installation. Use these IDs where appropriate in the specific panel being
used enrollment instructions.
verify programming and detector-to-panel communication
Before mounting, verify that the desired detector location provides good RF communication to the panel.
To verify programming And rf Communication
1. Put the panel into Dealer Sensor Test mode (refer to the specific panel installation instructions)
2. Take the detector to the desired mounting location.
3. Press and release the Test button. A quick beep will confirm the button has been pushed.
4. Listen for the appropriate response from system sirens to determine signal integrity from the detector to
the panel (refer to the specific panel installation instructions)
5. Exit from Dealer Sensor Test mode.
P/N 466-5308 • REV A • ISS 09MAY17 ©2017 United Technologies Corporation
23