Table of Contents
Advertisement
3.
After all detectors are powered on and the RED LED is glowing on/off, push and hold the Test/Hush
button on any one detector until two beeps are heard (approximately 4 seconds) and then release the
button. This detector will automatically create a new wireless network.
•
A brief series of quick GREEN LED blinks will occur and then the GREEN LED will fade on/off every
second on the button-pushed detector (network creator).
4.
Wait for the other wireless detectors to join the wireless network.
•
A brief series of quick GREEN LED blinks will occur and then the GREEN LED will fade on/off
approximately every 3 seconds.
NOTE: At this point, you can push/release the test button once on any detector, and the RED LED will
flash the number of enrolled detectors.
5.
Wait for the network setup to timeout (approximately 15 minutes), OR to immediately close the network,
push the Test/Hush button until two beeps are heard (approximately 4 seconds) and then release the
button. The network can be closed from any device enrolled in the network.
•
When the network has been closed, each detector's GREEN LED will change from glowing on/off
every second to flashing once every 60 seconds to indicate normal operation.
6. After selecting the proper location for your detector, attach the mounting bracket to the wall or ceiling. To
ensure aesthetic alignment of the detector with the hallway, or wall, the "A" line on the mounting bracket
must be parallel with the hallway when ceiling mounted or horizontal when wall mounted.
•
Install the detector fully on the mounting bracket (trim plate) by rotating the detector in a clockwise
direction. NOTE: The detector will mount to the bracket in 4 positions (every 90 degrees).
7.
The detector is now activated. After installation / activation, test your detector as described in
Operation and Testing section.
20
P/N 466-5308 • REV A • ISS 09MAY17
©2017 United Technologies Corporation
Hide quick links:
Advertisement
Table of Contents
