Uniden 4KTPD-MVF Installation Manual page 7

5. If you have a 4K TPD camera, connect the plugs from the
network cable tail to their appropriate cables.
When using an optional external power supply, the AC
socket outlet shall be installed near the equipment and be
If installed outdoors, the cable and all cable connections
must be routed inside the wall.
6. Align the camera base screw holes to the screws. Hang the
base onto the screws then slide the base along the screw lock
to secure.
7. Remove the protective films from the inside and outside of the camera dome and clean the
dome with a microfiber cloth (not included) if available.
Do not use a paper towel to clean the camera lens or dome as it might leave
8. Adjust the bracket to swivel the camera up to 175˚ on a
horizontal axis (orients the camera for top/bottom of frame).
9. Loosen screw 1 and adjust the camera from 15 - 90˚ on a
vertical axis.
10. Loosen screw 2 to fine-tune the horizontal axis (+/- 30˚).
As you adjust the camera position, check it through the
11. Insert an SD card if needed.
easily accessible.
NVR Preview screen.
scratches.
2.1mm Barrel Adapter
Red - Audio In
NOTE: 12VDC power supply
White - Audio Out
not included
Yellow - Video (BNC)
Red - 12VDC (optional)
RJ45
PoE
Red - Alarm Out
Network Black - Alarm In
Activity
LEDs
Screw Hole
and Lock
Swivel
Direction
Bracket
Screw 1
15˚ - 90˚
Screw 2
Reset Button
SD Card Slot
Swivel
Direction
7