Install Camera - Uniden 4KTPD-MVF Installation Manual

• Rubber plug (grommet) to seal network cable hole

Install Camera

1. Remove the camera and installation items from the box. Verify that all parts are there.
2. Position the installation template at the location (wall, ceiling, etc). Drill a 1" hole as indicated
on the sticker and install the anchors provided.
3. If your bullet camera is equipped with an SD slot, insert an
SD card now before you install the camera. Unscrew the
rectangular hinged panel and insert the SD card.
4. Thread the network cable tail through the grommet and connect
it to the house cabling through the 1" hole. Plug the grommet
into the hole. Using the screws provided, screw the camera
base into position.
When using an optional external power supply, the AC
socket outlet shall be installed near the equipment and be
If installed outdoors, the cable and all cable connections
5. Loosen screw 1 to rotate the camera and stand up to 360°.
Loosen screw 2 to adjust the camera body up to 90° and screw
3 to fine tune the camera position up to 90°. Loosen Screw 4 to
adjust the sun shade.Check the camera's position through the
NVR Preview screen as you adjust the camera.
12
easily accessible.
must be routed inside the wall.
SD Card Slot
Reset Button
2.1mm Barrel Adapter
Red - Audio In
NOTE: 12VDC power supply
White - Audio Out
not included
Yellow - Video (BNC)
Red - 12VDC (optional)
RJ45
PoE
Red - Alarm Out
Network Black - Alarm In
Activity
LEDs
4KB-MVF
Red - 12VDC (optional)
2.1mm Barrel Adapter
NOTE: 12VDC power supply
not included
RJ45
4MB-MVF, 2MB-VF
Screw 1
Screw 3
Screw 4
Screw 2
PoE