Install Large Bullet Cameras; What's Included - Uniden 4KTPD-MVF Installation Manual

2. Hold the camera and sleeve steady and unscrew the ring from
the base.
3. Position the installation template sticker on the location (wall, ceiling, etc). Drill a 1" hole as
indicated on the sticker. Install the anchors.
4. Position the base on the template, aligning the screw holes to the anchors, and screw it into
position.
5. Connect the network cable tail to the house cabling through the
1" hole.
When using an optional external power supply, the AC
socket outlet shall be installed near the equipment and be
If installed outdoors, the cable and all cable connections
6. Reassemble the camera unit. Remove the dessicant packet from the sealed plastic envelope
and position it inside the camera unit.
7. Screw the camera unit to the base securely enough to adjust
the camera position. Double check the position through the
NVR Preview screen.
Use an oil-free soft brush or blow gently into the camera
8. Tighten the ring to the base. Insert the set screws to lock the camera into position.

INSTALL LARGE BULLET CAMERAS

What's Included

• IP camera
• Mounting template sticker
• Camera-specific Allen wrench
• 2-wire to 2.1mm barrell plug for optional 12V DC power input
• Installation screws and anchors
• Dessicant package
easily accessible.
must be routed inside the wall.
dome to clear any dust or dirt.
Base
Ring
Sleeve
Camera
Red - 12VDC (optional)
2.1mm Barrel Adapter
NOTE: 12VDC power supply
not included
RJ45
Set Screw
Location (x2)
PoE
11