Agilent Technologies 8560E User Manual page 366

Programming Command Cross Reference
Programming Command Versus Front Panel Key
Table 6-4 Mass Memory Module Commands
IF
INT
KEYCLR
KEYDEF
LCLVAR
LIMD
LIMF
LIMIFAIL
LIMIPURGE
LIMIRCL
LIMIREL
LIMISAV
LIMITEST
LIML
LIMM
LIMTFL
LIMTSL
LIMU
LOG
MEAN
MEM
MENU
MIN
MOD
MODRCLT
MODSAVT
MOV
MPY
MSDEV
MXM
ONEOS
366
IF THEN ELSE ENDIF forms a decision and branching
construct.
Places the greatest integer that is less than or equal to the
source value into the destination.
Clears softkeys 1 through 6.
Assigns a label and user-defined function to a softkey.
Defines a local variable for use within a downloadable program.
Enters the delta amplitude value for a limit-line segment.
Enters the frequency value for a limit-line segment.
Returns a "0" if the last measurement sweep of trace A is equal
to or within the limit-line bounds.
Disposes of the current limit line, but not the limit-line table.
Recalls a limit line table from module memory.
Specifies a relative limit line.
Saves the current limit-line table in module memory.
Compares trace A with the current limit-line data.
Assigns an amplitude value to a limit-line segment in the lower
limit line.
Assigns a middle amplitude value to a limit-line segment.
Specifies a flat limit-line segment.
Specifies a sloped limit-line segment.
Assigns an amplitude value to a limit-line segment in the upper
limit line.
Takes the logarithm (base 10) of the source, multiplies the
result by the scaling factor, then stores it in the destination.
Returns the mean value of the given trace in measurement
units.
Returns the amount of spectrum analyzer memory available.
Selects and displays the softkey menus on the spectrum
analyzer screen.
Compares source 1 and 2, point by point, and stores the lesser
of the two in the destination.
Stores the remainder from the division of source 1 by source 2
in the destination.
Recalls the trace from module memory.
Saves the trace in module memory.
Copies the source values into the destination.
Multiplies the sources, point by point, and places the results in
the destination.
Specifies the mass storage device.
Compares source 1 and source 2, point by point, sending the
greater value of each comparison to the destination.
Executes the list of analyzer commands after the end of the
sweep.
Chapter 6