Gnss Module Rf Input Requirements - Cisco ASR 903 Installation Manual

Overview
Note Using a single GPS antenna input for both RSPs requires usage of external splitters.
Warning To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023
Note The GNSS module is not hot swappable.

GNSS Module RF Input Requirements

• The GNSS module requires an active GPS/GNSS antenna with built-in Low-Noise Amplifier (LNA) for
The Amplification required is 22dB gain + cable/connector loss + Splitter signal loss.
The recommended range of LNA gain (LNA gain minus all cable and connector losses) at the connector of
the receiver module is 22dB to 30dB with a minimum of 20dB and a maximum of 35dB.
• GNSS module provides 5V to the active antenna through the same RF input.
• Surge requirement:
GNSS modules have built-in ESD protections on all pins, including the RF-input pin. However, additional
surge protection may be required if rooftop antennas are being connected, to meet the regulations and standards
for lightning protection in the countries where the end-product is installed.
A lightning protection must be mounted at the place where the antenna cable enters the building. The primary
lightning protection must be capable of conducting all potentially dangerous electrical energy to PE (Protective
Earth).
Surge arrestors should support DC-pass and suitable for the GPS frequency range (1.575GHz) with low
attenuation.
• Antenna Sky visibility:
GPS signals can only be received on a direct line of sight between antenna and satellite. The antenna should
see as much as possible from the total sky. For proper timing, minimum of four satellites should be locked.
Note The antenna terminal should be earthed at the building entrance in accordance with the ANSI/NFPA 70, the
National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a
Coaxial Cable.
• Use a passive splitter if more than one GNSS modules are fed from a single antenna.
For information on pinout, see
optimal performance. The antenna LNA amplifies the received satellite signals for two purposes:
• Compensation of losses on the cable
• Lifting the signal amplitude in the suitable range for the receiver frontend
GPS Port
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
Pinout.
GNSS Module RF Input Requirements
23