Rsp Installation; Installing An Rsp Module - Cisco ASR 903 Installation Manual

Installing the Cisco ASR 903 Router
Figure 71: Fan Tray Removal
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the fan blades completely
stop before you remove the fan tray. Statement 258
Step 4
Wait at least 5 seconds to allow the fans to stop spinning. Then, pull the fan tray backward toward you and out of the
chassis.
As the fan tray slides out of the chassis, support the bottom of the fan tray with one hand and keep your other
Note
hand on the fan tray handle.
This completes the steps for removing the fan tray from the chassis.
To install the new fan tray, follow the steps

RSP Installation

Follow these steps on handling an RSP module in the Cisco ASR 903 Router:

Installing an RSP Module

To install an RSP module in the router chassis, perform the following steps:
Step 1
Choose a slot for the module. Make sure that there is enough clearance to accommodate any equipment that will be
connected to the ports on the module. If a blank module filler plate is installed in the slot in which you plan to install the
module, remove the plate by removing its 2 Phillips pan-head screws.
Step 2 Fully open both the ejector levers on the new module, as shown in the figure below.
To prevent ESD damage, handle modules by carrier edges only.
Caution
Step 3 Position the module in the slot. Make sure that you align the sides of the module with the guides on each side of the slot,
as shown in the figure below .
inInstalling the Fan
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
Tray.
RSP Installation
89