Swapping Of Interface Modules - Cisco ASR 903 Installation Manual

Swapping of Interface Modules

If you perform OIR on an interface module and move the module to a different slot, the router does not retain
the module configuration; you must reconfigure the interface module.
Replacing a configured interface module with a different interface module in the same slot is not supported
on the router.
When you remove or insert a redundant module while the router is powered on and running, the router does
the following:
1. Determines if there is sufficient power for the module.
2. Scans the backplane for configuration changes.
3. Initializes the newly inserted module. In addition, the system notes any removed modules and places those
modules in the administratively shutdown state.
4. Places any previously configured interfaces on the module back to the state they were in when they were
removed.
The router runs diagnostic tests on any new interfaces and the test results indicate the following:
• If the tests pass, the router is operating normally.
• If the new module is faulty, the router resumes normal operation but leaves the new interfaces disabled.
• If the diagnostic tests fail, the router stops operating, which usually indicates that the new module has a
Caution To avoid erroneous failure messages, note the current configuration of all interfaces before you remove or
replace an interface module, and allow at least 2 minutes for the system to reinitialize after a module has been
removed or replaced. This time is recommended in order to allow for synchronization between components
within the interface module and for synchronization with the standby RSP.
Swapping of Interface Modules
The Ethernet interface modules support swapping on the Cisco A900-RSP2A module.
• 8-port Gigabit Ethernet SFP Interface Module (8X1GE)
• 8-port Gigabit Ethernet RJ45 (Copper) Interface Module (8X1GE)
• 1-port 10 Gigabit Ethernet XFP Interface Module (1X10GE)
• SFP Combo IM—8-port Gigabit Ethernet (8X1GE) + 1-port 10 Gigabit Ethernet (1X10GE)
• Copper Combo IM—8-port Gigabit Ethernet (8X1GE) + 1-port 10 Gigabit Ethernet Interface
• 2-port 10 Gigabit Ethernet Interface Module(2X10GE)
Use the hw-module subslot default command before performing a swap of the modules. to default the
interfaces on the interface module.
Note
The hw-module subslot default command is not supported on the TDM and OC-3 interface modules.
Note
Always refer to Interface Module compatibility matrix tables in the Data Sheet before you swap any IM.
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
94
problem in the bus and should be removed.
Module(1X10GE)
Installing the Cisco ASR 903 Router