A900-Rsp2 And A900-Rsp3 Led Information - Cisco ASR 903 Installation Manual

A900-RSP2 and A900-RSP3 LED Information

LED
Management port (MGMT)
Sync status (SYNC)
USB flash (MEM)
BITS
A900-RSP2 and A900-RSP3 LED Information
The PWR and STAT LEDs are available on the front panel. These LEDs provide power on the board (PWR)
and overall router health (STAT) status. During power up state, these LEDs provide booting status and report
errors.
Note
The digital code signing functionality validates the integrity and authenticity of the ROMMON image before
booting it.
Table 44: A900-RSP2 and A900-RSP3 LED
PWR LED
State
Light
Green
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
178
Color/State
Off
Green
Flashing green
Off
Yellow
Flashing
yellow
Green
Flashing green
Off
Amber
Green
STAT LED Indication
State
Red Power is OK and the
field-programmable gate array (FPGA)
is nfigured successfully, but FPGA
image validation failed.
Description (two LEDs for each port)
No connection
Connected with no activity
Connected with activity
Not enabled
Free run
Holdover
Locked to source
USB activity
Out of service/not configured
Fault or loop condition
In frame/working properly
Comment
Image validation failed. System is in hung
state.
Troubleshooting