List Of Error Display / Indication; Operator Call Errors - Canon MX7600 Service Manual

MX7600

2. LIST OF ERROR DISPLAY / INDICATION

Errors and warnings are displayed by the following ways:
1. Operator call errors are indicated by the Alarm LED lit in orange, and the error and its solution are displayed on the LCD in
text and by icon.
2. Messages during printing from a computer are displayed on the MP driver Status Monitor.
3. Error codes are printed in the "operator call/service call error record" area in EEPROM information print
Buttons valid when an operator call error occurs:
1. ON/OFF button: To turn the machine off and on again.
2. OK button: To clear and recover from an error. In some operator call errors, the error will automatically be cleared when
the cause of the error is eliminated, and pressing the OK button may not be necessary.
3. Stop/Reset button: To cancel the job at error occurrence, and to clear the error.
2-1. Operator Call Errors (by Alarm LED Lit in Orange)
Error
No paper in the rear
tray.
No paper in the
cassette.
Paper jam.
Paper jam in the rear
guide (when paper
feeding from the
cassette).
Paper jam in the
under guide (during
automatic duplex
printing).
Ink may have run
out.
Ink tank not installed. [1660] U043 The following ink tank cannot
No Clear ink.
Print head not
installed, or not
properly installed.
Faulty print head ID.
Print head
temperature sensor
error.
Faulty EEPROM data [1405]
Error U No.
Message on the LCD
code
[1000] --- Rear tray.
There is no paper. Load paper
and press [OK].
[1003] --- Cassette.
There is no paper. Load paper
and press [OK].
[1300] --- The paper is jammed. Clear
the paper and press [OK].
[1303] ---
[1304] ---
[1600] U041 The ink may have run out.
U044 Replacing the ink tank is
recommended.
be recognized.
(Applicable ink tank icon)
[1692] U045 The clear ink tank is empty.
[1401] U051 Print head is not installed.
Install the print head.
[1401] U052 The type of print head is
incorrect. Install the correct
[1403]
print head.
Confirm that the rear tray is selected as the paper source.
Set the paper in the rear tray, and press the OK button.
Confirm that the cassette is selected as the paper source.
Set the paper in the cassette, and press the OK button.
Remove the jammed paper, and press the OK button.
Replace the applicable ink tank, or press the OK button to
clear the error without ink tank replacement. When the
error is cleared by pressing the OK button, ink may run
out during printing.
Install the applicable ink tank(s) properly, and confirm
that the LED's of all the ink tanks light red.
Replace the Clear ink tank with a new one, or press the
OK button to continue printing without Clear ink tank
replacement. However, when Clear ink is completely used
up, no further printing on plain paper can be performed
unless the empty Clear ink tank is replaced with a new
one.
Install the print head properly.
Re-set the print head. If the error is not cleared, the print
head may be defective. Replace the print head.
5 / 65
TABLE OF CONTENTS
Solution