List Of Error Display / Indication; Operator Call Errors (By Led Blinking In Orange); Service Call Errors; Orange - Canon PIXUS 50i Service Manual

Table of Contents

Advertisement

2. LIST OF ERROR DISPLAY / INDICATION

Errors are indicated by the LED, and warnings are displayed on the monitor of the computer connected to
the printer.

2.1 Operator Call Errors (by LED Blinking in Orange)

LED
blinking in

orange

2 times
No paper.
3 times
Paper jam.
6 times
The print head is not installed.
7 times
The print head is not installed
properly. (EEPROM data of
the print head is faulty.)
8 times
Warning: The waste ink
absorber becomes almost full
(to approx. 95% of the
maximum capacity).
9 times
The black or color ink tank is
not installed, or not installed
properly.
10 times
Low battery
2.2 Service Call Errors (by LED Blinking in Orange and Green Alternately, or Lit
in Orange)
LED
alternate blinking
in orange and
green
2 times
4 times
6 times
7 times
8 times
9 times
Lights in orange
*1: As the waste ink counter is reset when the logic board ass'y is replaced, also replace the 4-item set of the
drain pack ass'y (QL2-0194) and the 3 ink absorbers (QC1-1210/1211/1212) at the same time.
*2: The waste ink absorber full error occurs when either the main waste ink absorber (drain pack ass'y) or the
borderless printing waste ink absorber (ink absorber) becomes full. For this reason, all the waste ink
absorbers should be replaced at the same time.
Error
Error
Carriage error
Purge unit error
Internal temperature
error
Waste ink absorber full
Print head temperature
rise error
EEPROM error
RAM error
Solution
Set the paper, and press the
Resume/Cancel button.
Remove the jammed paper, and press
the Resume/Cancel button.
Install the print head, and close the print
head cover.
Re-install the print head, or with the
print head installed, turn the printer off
and on.
Pressing the Resume/Cancel button will
exit the error, and enable printing.
In repair servicing, replace the 4-item
set of the drain pack ass'y (QL2-0194)
and the 3 ink absorbers
(QC1-1210/1211/1212) at the same
time.
Install both the black and color ink
tanks. If they are installed, reseat them
properly.
Charge the battery, or connect the AC
adapter to resume printing.
Replace the logic board ass'y
Replace the print unit.
Replace the print unit.
Replace the 4-item set of the drain pack ass'y (QL2-0194) and
the 3 ink absorbers (QC1-1210/1211/1212) at the same time
Replace the print head, or the logic board ass'y
Replace the logic board ass'y
Replace the logic board ass'y
1 - 4
Remarks
The service call
error, indicating the
waste ink absorber
is full, is likely to
occur soon.
If the error persists
after the ink tanks
are seated properly,
the ink tank sensor
is likely to be
faulty.
Solution
*1
, or the print unit.
*1
.
*1
.
*1
.
*2
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pixus i70

Table of Contents