2. LIST OF ERROR DISPLAY / INDICATION
Errors are indicated by the LED, and warnings are displayed on the monitor of the computer
connected to the printer.
2.1 Operator Call Errors (LED Blinks in Orange)
Note: The color red indicates changes from the i70 / PIXUS 50i base model.
Either black or color ink
tank (or both ink tanks) is
not installed, or not
The print head is not
installed properly or the
print head has problems.
Warning: The waste
ink absorber is almost
full (approx. 95% of the
Communication with the
digital camera has been
The connected digital
camera or digital video
camera is not supported
by the PIXMA iP90 /
* For the PIXMA iP90 / PIXUS iP90, it is possible to reset 'main waste ink counter' and 'platen waste
ink counter' respectively.
For the i70 / PIXUS 50i and i80 / PIXUS 80i, they are reset at the same time.
Set paper, and press the
Remove the jammed paper, and press
the Resume/Cancel button.
Install both black and color ink tanks.
When the ink tanks have been already
installed, re-install them.
- Install the print head (when the print
head has been already installed,
re-install it), and close the print head
- With the print head installed, turn the
printer off and on.
Pressing the Resume/Cancel button
cancels the error and resumes printing.
In repair servicing, replace the following
items and reset the appropriate waste
- Main waste ink absorber:
Drain pack ass'y (QL2-0194)
- Platen waste ink absorber:
Three items are to be replaced at
the same time.)
Disconnect the cable from, both the
digital camera and the printer, and
press the Resume/Cancel button.
Reconnect them and try again.
Put the battery on charge or print with
the AC adapter.
If the error
persists, the ink
tank sensor may
The service call
the waste ink
absorber is full, is
likely to occur