Canon MX7600 Service Manual page 57

3) In the printout, select the Pattern No. in which streaks or lines are the least noticeable.
3-1) LF correction value
Press the Stop/Reset button the same number of time(s) as the selected Pattern No., then press the ON/OFF button.
Selected pattern
number
1
0
2
- Each time the Stop/Reset button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and
Power in green.
- If the Stop/Reset button is pressed 3 times or more, then the ON/OFF button is pressed, the machine returns to
the service mode menu selection.
3-2) Eject correction value
Press the Stop/Reset button the same number of time(s) as the selected Pattern No., then press the ON/OFF button.
Selected pattern
number
1
0
2
- Each time the Stop/Reset button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and
Power in green.
- If the Stop/Reset button is pressed 3 times or more, then the ON/OFF button is pressed, the machine returns to
the service mode menu selection.
4) The selected LF correction value or Eject correction value is written to the EEPROM, and the flag for the E-MIP correction
value becomes OFF, enabling the LF / Eject correction values written to the EEPROM. Then, the flag for the fixed value of
the endurance correction becomes ON, and the machine returns to the service mode menu selection.
Number of times the Stop/Reset button is
pressed (M)
1 time
0 times
2 times
Number of times the Stop/Reset button is
pressed (N)
1 time
0 times
2 times
55 / 65