Table of Contents
Advertisement
6. Contact i-feel's technical service through our home page at www.i-feel.co.il
7. Incorrect username and password - You must provide a user name and password and
stick to them when entering the controller
Symptom - A dynamic scenario is running in an inaccurate timing
A possible cause of the phenomenon
1. Network connection problem
2. Partial definition of user data in app settings
Recommendations for solving the problem
1. Set the settings tab:
a. Exact latitude and latitude of the location - the following site can be used to locate the
data: https://www.latlong.net
b. Make sure COUNTRY is correct for the country you are in
third. TIME ZONE +2 GMT ISRAEL TEL AVIV / JERUSALEM must be set
Symptom: Failed to add new unit
A possible cause of the phenomenon
1. Testing the distance between a physical unit and a controller
2. Background noise test - no environmental factor affecting the internal communication
(possible with the use of ToolKit)
3. A fault in the end unit
4. Location of the controller relative to the other end units
5. Internal noise source
Recommendations for solving the problem
1. It is necessary to ensure that the direct distance of each end unit shall not exceed 5-7
meters. If the distance exceeds the direct range, the relay points shall be added to serve as
a range booster. Each point will be connected to L and N and will increase the home
network as part of the MESH network.
2. If there are external noises, consider the relevant positions and re-adjust the position of
each unit optimally where the noise will be minimal for each unit.
3. Make sure to contact i-feel, you can contact us through the homepage: www.i-feel.co.il
4. A central position of the controller should be maintained. If the house has 3 levels, the
controller unit should be located on the middle floor.
5. Make sure that there is no proximity between the controller unit and factors with an
internal noise source, such as an external power transformer with high power
Delay symptom (too long-time gap) between a command mission from the controller and
feedback on the end unit
36
Advertisement
Table of Contents
