Table of Contents
Advertisement
In the Advanced tab, the user can update and reset/heal the Z-Wave network. There is also
possibility to remove a unit, by entering the node ID in the Remove by note ID field.
A user with technician privileges can perform this action!
NETWORK RESET - This is a sweeping reset of all Z-WAVE units on the network, including
the disconnection of existing units from the controller only! Once we want to reuse these
units, a local RESET must be performed for each unit at the endpoint. This means that even
if NETWORK RESET is done and we want to go back to the previous step, you can load an
existing backup in the system and the endpoint units can communicate immediately with
the management unit.
NETWORK HEALING - This is the stage that takes place after all the end units have been
defined in the structure and after the functionality of each one has been tested. The purpose
of the procedure is to cure and optimize the communication between the management unit
and the end units. The duration of the procedure varies from apartment to apartment and on
average is about 15 minutes. While the procedure is being performed, do not touch / change
and / or physically and / or virtualize the endpoints for the success and efficiency of the
recorder.
24
Advertisement
Table of Contents
