Returning to Standby Mode
When the UPS is in Operate mode (the Utility LED is solid green), press and
hold the STANDBY button (2) until the audio alarm sounds. This will place
the UPS in Standby mode. The Utility LED (1) will flash, and power to the
loads will cease.
Figure 3-3. Placing the UPS in Standby mode from Operate mode
1
Utility LED
2
STANDBY button
IMPORTANT:
While in Standby mode, the UPS maintains the charge on the batteries, but no power
is available at the output receptacles.
The UPS remains in Standby mode until an alternate mode is selected, or until utility
power is removed.
2
Operation 3-9
1