Before Starting The Ups - Compaq T2200 XR Operation And Reference Manual

Hardware
The UPS ships with one or more of the following:
Cable(s)
! The T2200 XR NA and T2200 XR JPN models ship with a
non-detachable input power cord and a 6-foot UPS/computer
interface cable, Compaq part number 201092-001.
!
The T2200 XR H NA and T2200 XR H INT'L models ship with a
detachable country-specific input power cord; a 6-foot
UPS/computer interface cable, Compaq part number 201092-001,
for load equipment power; four 10-amp, 6-foot, IEC to IEC power
cords, Compaq part number 142263-001, and two 8-foot IEC to IEC
power cords, Compaq part number 142263-002.
All models ship with a computer interface cable. The computer interface cable
is not needed for normal operation. If power management of the UPS is
desired, connect the interface cable between the UPS communications port and
the serial port on the host computer.
WARNING: Risk of personal injury from electric shock.
The UPS T2200 XR H NA and T2200 XR H INT'L models are not suitable for
installation where the total Earth (ground) conductor leakage current for all
connected devices exceeds 3.5 mA.
IMPORTANT: If the UPS does not include a power cord that is suitable for your
application, contact an authorized Compaq service representative to obtain the
appropriate power cord. Please refer to the "Precautions for Power Products" section of
the Important Safety Information (guide included with the UPS kit).

Before Starting the UPS

This section provides installation steps to be completed before starting the
UPS.
Determine the steps required for the application:
Connecting the UPS communications port to the host computer
Connecting the Network Transient Protector
NOTE: Although these steps can be carried out after the UPS is installed, it is
recommended that the UPS be powered down to safely perform these tasks.
Installation 2-3