Table of Contents
Advertisement
OPERATING INSTRUCTIONS
CHECKLIST BEFORE STARTING
VERIFY ALL CHECK POINTS BEFORE STARTING. FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURIES.
1.
Make sure you and any assistants are wearing safe and appropriate workshop attire.
2.
To reduce the risk of damage to the machine, as well as potential for personal injury, after initial set-up as well
as before each use, make sure that everything is securely installed and that all fasteners and moving parts on
this machine are locked in place before starting the machine.
3.
Make sure to have on safety glasses as well as hearing or/and respiratory protection at all times when using the
machine.
4.
Check the level of coolant in the tank and fill it as necessary. The maximum level is 5 liters.
5.
Use only recommended parts and accessories. The use of parts or accessories NOT recommended by
GENERAL® INTERNATIONAL may result in a risk of injury or damage to the machine.
6.
Be sure that adjusting wrenches, tools, drinks and other clutter are removed from the machine and/or the
table surface before operating.
OPERATIONS STEP-BY-STEP
NEVER USE THE SAW WITHOUT ALL GUARDS AND COVERS IN PLACE. BEFORE STARTING THE SAW BE SURE THAT THE
BLADE IS NOT ALREADY IN CONTACT WITH THE WORKPIECE.
1.
Trace the cutting line on your workpiece with a pen-
cil and clamp the material firmly in the vise jaws.
Make sure the workpiece is properly secured in the
vise.
Note: Use the work stop to quickly and accurately cut mul-
tiple pieces of stock to the same length.
2.
Press button A to start the machine. Adjust the blade
speed with knob B.
3.
Turn on the coolant pump by turning switch C to the
right and opening the coolant valve D.
4.
Press on the downfeed handle trigger while smooth-
ly lowering the saw head.
5.
Once the cut is completed, raise the head and
release the trigger. Turn OFF the pump by turning
switch C to the left.
6.
Press button E to turn off the machine.
7.
Carefully remove the workpiece from the vise.
BURN DANGER: DO NOT USE BARE HANDS TO TOUCH
THE WORKPIECE AT THE CUT LOCATION UNTIL IT HAS
COOLED.
Note: Before operation, see the chart below regarding the
cutting capacity of your machine based on the size and
shape of the workpiece.
WORKPIECE
Straight cut
3 3/8" (85 mm)
Cut at 45°
3" (75 mm)
18
CUTTING CAPACITY
4 3/4" (120 mm)
4" X 4" (102 x 102 mm)
3 3/4" (95 mm)
3 1/8" X 3 1/8" (80 x 80 mm)
C
D
OPENED
CLOSED
D
6 1/8" X 3 1/2" (155 x 90 mm)
3 1/8" X 2 3/4" (80 x 70 mm)
B
A
E
Advertisement
Table of Contents
