Table of Contents
Advertisement
Controls and signals on the panel (Fig 30):
1 ON/OFF switch: allows control panel activation.
The display 2 and the LED 11 are switched on
2 Display: allows generator operation to be moni-
tored. It shows the operation state and any
messages related to internal diagnostics
3 MENU / BOOST button, dual function key:
pressed normally it allows scrolling the various
menus or confirming the selected options, held
down for at least 3 seconds allows the BOOST
function to be activated or deactivated. This
function must be activated when you are plan-
ning to apply to the generator a single load
with power exceeding 60% of the rated power.
4 Auto button, dual function button: within the
MENUS, it scrolls back through the available
options; with an active panel it allows the
AUTO function to be activated or deactivated.
This function controls the automatic generator
start and stop respectively on reaching the
start threshold and the stop threshold set.
5 Start/Stop button, dual function button: within
the MENUS, it scrolls forward through the
18
GB
available options; with an active panel it en-
ables the generating set start and stop. Press
it to cancel the AUTO function.
6 LED Booster, it illuminates when the BOOST
function is on (fig.30 ref. 3)
7 MAINTENANCE red LED: the display shows
the type of required maintenance (engine lu-
bricating oil level check or replacement).
8 ALARM red LED: indicates a fault. The display
provides detailed information on the fault de-
tected by the system.
9 GEN ON LED: it illuminates when the genera-
tor is in operation. The display shows the pa-
rameters relating to the state of operation of
the generator.
10 AUTO LED: it indicates that the corresponding
function is active
11 ON LED: indicates that there is power to the
panel.
12 microUSB port: used to perform diagnostic
tests or software updates for the generator via
a PC.
On the back of the panel are a connector for the
connecting cable to the generator (fig.31 ref. 1)
and the RJ11 connector for connection to an do-
motics control unit.
TIG 3000 G
Vers. 001
Advertisement
Table of Contents
