Table of Contents
Advertisement
4.2.2 Hanging installation
The generator is provided with supporting brack-
ets designed for fixing in a hanging configuration.
Figure 6 shows the arrangement of the fixing
brackets and vibration damping cylinders.
Figure 7 shows the generator with the mounting
brackets and damping mounts correctly installed
on the generator.
The vibration damping cylinders are
designed to work in compression and must
be assembled as shown in figures 6 and 7.
Installation in a pulling configuration as
shown in fig. 8 is strictly not permitted!
10
GB
Ensure that the ride height of the gen-
erator is not such as to risk contact with the
ground during travel. A good rule is to ensure
that the ride height of the lowest point of the
generator is not less than that of the other
components of the vehicle on which it is in-
stalled.
4.2.3 Floor mounting
The TIG3000G can be installed on a table/shelf.
To do this remove the two support brackets (fig.
9 ref. 1) from the upper part of the generator, ro-
tate them 180 degrees and attach them to the
lower part using the screws (fig. 9 ref. 2), as indi-
cated. Once the task has been completed make
sure all the screws that lock the two brackets are
securely.
TIG 3000 G
Vers. 001
Advertisement
Table of Contents
