Renesas H8S/2338 Series User Manual page 22

4. In the H8S/2338 series MCU, the interrupt signal pins can be selected by the register setting. To
trace the interrupt signals in the E6000 emulator, select the interrupt signal pins by setting switch
P5 on the user system interface cable as shown in table 2.
Table 2 Switch P5 Setting
IRPAS Bit Value
0
(Initial value)
1
5. In the H8S/2338 series MCU, the WAIT signal pins can be selected by the register setting. To
trace the WAIT signals in the E6000 emulator, select the WAIT signal pins by setting switch P4
on the user system interface cable as shown in table 3.
Table 3 Switch P4 Setting
WAITPS Bit Value
0
(Initial value)
1
16
Interrupt Signal Pin
IRQ4
IRQ5
IRQ6
IRQ7
IRQ4
IRQ5
IRQ6
IRQ7
Pin No.
4
108
Pin No.
40
34 Close between 2 and 3
33 (setting at shipment)
32
105
106 Close between 1 and 2
107
108
P4 Setting
Close between 3 and 4
(setting at shipment)
Close between 1 and 2
P5 Setting