Panasonic WJ-MPU955 Operating Instructions Manual page 7

r Hard Disk Drive Indicator (HDD)
The HDD indicator r indicates the hard disk drive sta-
tus.
t Active Indicator (ACTIVE)
The ACTIVE indicator t indicates the system status of
the WJ-MPU955.
y Ethernet Ports (10BASE-T/100BASE-TX)
The Ethernet Ports y exchange control data via
Ethernet. The CPU can contain up to three Ethernet
ports. In a standard setup, we suggest you use the first
Ethernet port [SYSTEM CONTROLLER] for system con-
trollers while the second port [ENCODER/DECODER]
for video encoders and decoders. The third port
[OTHER] is reserved for future use.
u Controller Ports [SYSTEM CONTROLLERS (RS-485)]
The controller ports u are provided for controlling the
system with WV-CU360C system controllers. Up to 12
controllers can be connected.
i Peripheral Interface Ports [PERIPHERAL INTER-
FACE (RS-232C)]
These ports i are reserved for future use or factory
tests.
o Redundant CPU Selector (REDUNDANT CPU)
The selector o can be set to either a redundant system
or a standalone system. The factory default setting is
NO, for standalone.
!0 Mode Selector (SATELLITE MODE)
The mode selector !0 is always kept in STANDALONE
position.
!1 Parallel Port (PARALLEL)
The parallel port !1 is used to connect to the WJ-
MPS855 CPU Switch Unit for a redundant system.
!2 Cooling Fan Unit
The cooling fan unit !2 prevents the temperature of the
CPU from rising. Do not block the ventilation opening
on the cover.
!3 Fuse Holder
The fuse holder !3 is shown in rear view diagram.
!4 AC Inlet Socket (AC IN)
Plug the power cord (supplied as a standard accesso-
ry) into this socket !4 and connect it to an AC outlet.
!5 Screws to access the power switch.
7