I Patrol Learn And Play; I Camera Panning Function - Panasonic WJ-MPU955 Operating Instructions Manual

I Patrol Learn and Play

The following function requires the use of cameras
equipped with this specific feature.
A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Press the [F2] button three times.
"LEARN" as shown in the figure will appear on the LED
display of the controller.
ALARM
ACK
DISARM
GROUP PRESET
PREV
OPE ID S-CTL ID
LOG OUT
PAUSE
CAM MENU OFF
GROUP
F1 SEQ
F2
OSD
CAM FUNC
To save the patrol sequence, follow the procedure
shown below.
q Press the [2] button, then press the [CAMERA
(ENTER)] button to start Patrol Learn.
"LE R" appears on the LED display to indicate the
selected mode.
w Operate the camera manually. Operations data
(patrol sequence) is stored.
e Press the [3] button to end the learning.
"LE S" appears on the LED display to indicate the
selected mode.
To reproduce the stored data, follow the procedure
shown below.
q Press the [1] button to reproduce the stored Patrol
function.
"LE P" appears on the LED display to indicate the
selected mode.
w Press the [3] button to end the reproduction.
3. To exit from the mode, press the [CLEAR (ESC)] but-
ton.
52
RESET
ALL RESET
NEXT
T&D CAM ID GEN
AUX1 OFF AUX1 ON WIPER
ALM S VLD S SYS S
STOP
MON STATUS
ALL
CAM MENU ON
AUX2 OFF AUX2 ON
TOUR
ALM H VDL H
SEQ
DEF OFF DEF ON
CLEAR
( ESC )
MONITOR
LOCK
SHIFT BLK EXIT
OSD SERVICE

I Camera Panning Function

The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Press the [F2] button four times.
"PAN" as shown in the figure will appear on the LED
display of the controller.
ALARM
DISARM
PROGRAM
PRESET
GROUP PRESET
OPE ID
LOG OUT
CALL
PRESET
CAM MENU OFF
F1
CAMERA
( ENTER )
F2
AUTO
PAN
CAM FUNC
3. Press the assigned numeric button shown below to
activate the panning function of the selected camera.
The LED display indicates the selected mode as fol-
lows.
1: Activates Auto Pan "PA PA".
2: Activates Sort Pan "PA SO".
3: Activates Sequence Pan "PA SE".
4: Activates Random Pan "PA RP".
Notes:
• The AUTO MODE parameter previously set in the
camera setup menu will be automatically replaced
to the activated function parameter.
• Random Pan function is not currently supported.
4. To exit from the mode, press the [CLEAR (ESC)] but-
ton.
ACK RESET
ALL RESET
PREV NEXT
T&D CAM ID
S-CTL ID
AUX1 OFF AUX1 ON
ALM S VLD S
PAUSE STOP
MON STATUS
CAM MENU ON
AUX2 OFF AUX2 ON
GROUP
TOUR
ALM H VDL H
SEQ
SEQ
DEF OFF DEF ON
OSD MONITOR
LOCK
SHIFT BLK
OSD SERVICE
PROGRAM
PRESET
GEN
WIPER
SYS S
ALL
CALL
PRESET
CLEAR
CAMERA
( ESC )
( ENTER )
EXIT
AUTO
PAN