Table of Contents
Advertisement
The factory default settings below are up is commented out by "*".
default=192.168.200.1
***{ Network entries must be grouped together although any number of entries is allowed. }
***{ Format: network=<destination>,<gateway>,<netmask>
*network=64.0.0.0,192.168.200.44,255,0,0,0
*network=88.0.0.0,192.168.200.88,255,0,0,0
*network=33.5.0.0,192.168.200.66,255,0,0,0
*network=64.0.0.0,192.168.200.55,255,0,0,0
***{ Host entries must be grouped together although any number of entries is allowed.
***{ Format: host=<destination>,<gateway>
*host=33.44.55.66,192.168.200.66
*host=11.22.33.44,192.168.200.44
SNTP section
[CAUTION] This section should not be changed.
This section allows changes to Simple Network Time Protocol parameters, if SNTP is implemented.
***{ This section is optional. It is not required unless
***{ System defaults are not acceptable. Delete the
***{ single asterisks below to make this section active.
***{ This section lists user-defined client SNTP values,
***{ sync rates and an external server address.
***{
***{ Format:
(VALUES INTERNAL TO THIS UNIT)
***{
ClientMode=<mode> (act as an SNTP client)
***{
modes: 0 - Internal (default)
***{
***{
***{
***{
ServerMode=<mode> (to expose its timestamp to
***{
other units)
***{
modes: 0 - Off
***{
***{
InternalFrequency=<time frequency of sync (secs)> }
***{
-default is 600 sec (10 min)
***{
***{
(VALUES FOR EXTERNAL CONNECTION)
***{
NTPServerIPA=<IPA> of SNTP server
***{
-for Unicast mode only; optional for
***{
modes 0,2,3.
***{
ExternalFrequency=<time frequency of sync (secs)> }
***{
-default is 18000 sec (5 hrs)
***{
TZOffset=<hour> time zone offset from GMT
***{
(+,-12 in integer values)
***{
DaylightSaving=<on/off> (applies for the local
***{
time zone)
***{
on/off: 0 - off
***{
*ClientMode=1
*ServerMode=1
*InternalFrequency=600
*NTPServerIPA=192.168.200.XXX
*ExternalFrequency=18000
*TZOffset=5
*DaylightSaving=1
1 - Unicast
2 - Anycast
3 - Broadcast
1 - On (default)
1 - on
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
23
Advertisement
Table of Contents
Troubleshooting
