Panasonic WJ-MPU955 Operating Instructions Manual page 33

G Pan/Tilt Control
(Program Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the camera to the position to be preset by mov-
ing the Joystick Controller and pressing the lens control
keys.
3. Select the desired preset position number by pressing
the numeric keys.
4. Holding down the [PGM PRESET] key, and then press
the [CAMERA (ENTER)] key to save a preset position
of the camera.
INFORMATION
Entry:48
1 2
T&D CAM ID
ALM S VLD S
( ALARM ) 4 5
MSTATUS
ALM H VLD H
7 8
0
SHIFT BLK
Notes:
• If the position number entered has been stored
previously, the old position will be overwritten by
the new one.
• This function is disabled when the WV-CS600
Series or WV-CS650 Series Camera is connected
to the Encoder.
G Pan/Tilt Control (Call Preset Position)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the preset position number by pressing the
numeric keys.
INFORMATION
Prg Preset48
3
LOGOUT AREA
GEN
AUX1 OFF AUX1 ON
SYS S
CALL PGM
6
PRESET PRESET
ALL
AUX2 OFF AUX2 ON
9 C A M DIGITAL
P O S I OUT
DEF OFF DEF ON
CAMERA
CLEAR
(ENTER)
(ESC)
EXIT AUTO PAN
3. Press the [CALL PRESET] key to move to the preset
position of the selected camera on the active monitor.
INFORMATION
Entry:52
1 2
T&D CAM ID
ALM S VLD S
4 5
( ALARM )
MSTATUS
ALM H VLD H
7 8
0
SHIFT BLK
Note: To be able to use the above function, the preset
position number must have been set for that cam-
era.
INFORMATION
Preset 52
3
LOGOUT AREA
GEN
AUX1 OFF AUX1 ON
SYS S
CALL PGM
6
PRESET PRESET
ALL
AUX2 OFF AUX2 ON
9 C A M DIGITAL
P O S I OUT
DEF OFF DEF ON
CAMERA
CLEAR
(ENTER)
(ESC)
EXIT AUTO PAN
33