Replacing The Compact Flash Memory Card - Motorola BSR 2000 Installation Manual

BSR 2000 Installation Guide
Figure 2-12 Connecting a Console Monitor to the BSR 2000

Replacing the Compact Flash Memory Card

The BSR 2000 uses a 128 MB Compact Flash (CF) memory card, installed at the
factory, to store configuration files and software updates. The Compact Flash card is
hot-pluggable, and may be removed or replaced without powering down the BSR
2000. The Compact Flash card slot is located behind a removable access door on the
front panel.
To remove or replace a Compact Flash memory card, follow these steps:
1. Remove the flash card cover by using a flat-head screwdriver to loosen the
2. Push the ejector button, located to the left of the flash card connector. See
3. Pull the flash card straight out of the connector. See
2-18
CONSOLE
NETWORK
1 3 5
0 2 4
captive screw. See Figure
The flash card cover swings out towards you.
Figure 2-14.
The flash card cover was designed to double as a removal tool. If you have
trouble grasping the edge of the flash memory card, use the hooks provided at the
end of the flash card cover to hook onto the tab on the underside of the flash
memory card and pull it out.
DB-9 RS-232
crossover connector
bsr2k008
To terminal, PC,
or workstation
2-13.
MGBI
Figure 2-14.
526359-001