Connecting Twisted-Pair Cables - Motorola EX-3524 Installation Manual

20
4. Slide the transceiver into the slot until it clicks into place. If you do not immediately connect a cable to the
port, use a rubber protective cap to keep the transceiver optics clean.
NOTE

3.4.2 Connecting Twisted-Pair Cables

The RJ-45 ports on the switch support automatic MDI/MDI-X pinout configuration, which enables you to use
standard straight-through twisted-pair cables to connect to any other network device (PCs, servers, switches,
routers, or hubs).
The connection requires an unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable with RJ-45
connectors at both ends.
Cable Type
100BASE-T
Category 5, 5e or 100-ohm UTP or STP
100BASE-TX
Category 5 or better 100-ohm UTP or STP
10BASE-T
Category 3 or better 100-ohm UTP
To ensure proper operation when installing the switch into a network, make sure that the current cables are
suitable for 10BASE-T, 100BASE-TX, or 1000BASE-T operation. Check the following criteria against the current
installation of your network:
• Cable type: Unshielded twisted pair (UTP) or shielded twisted pair (STP) cables with RJ-45 connectors;
Category 5, 5e or better cable for 1000BASE-T connections, Category 5 or better for 100BASE-TX
connections, and Category 3 or better for 10BASE-T connections.
• Protection from radio frequency interference emissions
• Electrical surge suppression
• Separation of electrical wires (switch related or other) and electromagnetic fields from data based
network wiring
• Safe connections with no damaged cables, connectors or shields
To remove a transceiver, disconnect the network cable then pull the tab to remove the
transceiver from the slot.
Maximum Cable Length
100 m (328 ft)
100 m (328 ft)
100 m (328 ft)
EX-3524/EX-3548 Layer 2 Gigabit Ethernet PoE/PoE+ Switch
RJ-45
RJ-45
RJ-45
Connector Type