BSR 2000 Installation Guide
Installing the BSR 2000 on a Desktop
To install the BSR 2000 on a desktop follow these steps:
1. Attach the four rubber feet to the bottom of the BSR 2000 in the locations shown
2. Remove each rubber foot from its protective paper (protects the adhesive side),
3. Place the BSR 2000 in its intended location on the desktop.
Circular
depression
Figure 2-4 Attaching Rubber Feet to the Bottom of the BSR 2000 Enclosure
Connecting Network Cables
You connect the following kinds of cables to the BSR 2000:
2-8
in
Figure
2-4.
Three of the rubber feet should be placed in the circular depressions shown. The
fourth should be placed at the rear of the cutout area, as shown.
and press it firmly so that it adheres to to the bottom of the BSR 2000 chassis.
DWN STRM
UP STRM
0
0
1
2
SYSTEM
ALM
PWR
FAIL STS ALM
RED
STS
Cutout
area
A shielded DB-9 console cable
Shielded Twisted Pair (STP) Ethernet cables equipped with shielded RJ-45 plugs
Ethernet cables equipped with LC-type fiber optic plugs
One coaxial cable for the BSR 2000 downstream channel
Up to four coaxial cables for the BSR 2000 upstream channels
One coaxial cable for the BSR 2000 wireless port
One shielded RJ-48 cable for the BITS interface
CONSOLE
NETWORK
3
1
2
3
R/W RESET
BSR 2000
0
2
3
Placement of
rubber feet
MGBI
bsr2k039
526359-001