Motorola BSR 2000 Installation Manual page 34

BSR 2000 Installation Guide
Note: To maintain regulatory compliance, use only Motorola tested and
approved SFP modules. Refer to the price catalog for available modules.
3. Connect a cable to the connector on the SFP, as shown in
4. Connect the other end of the cable to the assigned Ethernet port on the router,
Note: The BSR 2000 utilizes LC connectors for its optical interfaces. To
interface with equipment that utilizes SC connectors, you will need to use the
appropriate LC-SC cables or adapters. Refer to the price catalog for available
cables.
5. Repeat steps 1 through 4 to install a second SFP module in the remaining Gigabit
2-12
Bits
RED
Remove EMI plug
Figure 2-7 Installing SFP Modules
hub, or switch.
Ethernet port and connect cables to it.
5
1 2 3 4
0
Install SFP module
MGBI
bsr2k041
Figure 2-8.
526359-001