Enable Enhanced Password; Disable Port 77F0 (Hex); Default Settings (Option 7); Channel 1 Configuration - Lantronix WiPort User Manual

Enable Enhanced Password

The Enhanced Password setting allows you to set a password of up to 16 characters
for protecting Telnet and Web Page access. We recommend that you select the Y
(Yes) option and enable the enhanced password setting.
Avoid using either the 4 character basic password setting or no password at all as
they are not secure options.

Disable Port 77F0 (Hex)

Port 77F0 allows a custom application to query or set the eleven WiPort configurable
pins when they are functioning as general purpose I/O (GPIO). Disable this
capability, if desired, for security purposes.
The default setting, the N (No) option, enables GPIO control. The Y (Yes) option
disables the GPIO control interface.

Default Settings (Option 7)

Select 7 Defaults from the Change Setup menu to reset the unit's Channel 1
configuration, Channel 2 configuration, E-mail settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, netmask, wireless enable, infrastructure or ad hoc setting, and wireless
security settings remain unchanged. The configurable pins' settings also remain
unchanged. The specific settings this option changes are listed below.
Note: To reset network settings to factory defaults, use one of the "Reset to
Defaults" Configurable Pin Settings. For more information on Configurable
Pins, see

Channel 1 Configuration

Baudrate
I/F Mode
Port No
Connect Mode
Hostlist Retry Counter
Hostlist Retry Timeout
Send Character
All other parameters
WiPort Embedded Wireless Device Server User Guide
key length, 48 characters for 192 bits key length, or 64 characters
for 256 bits key length.
Enable Enhanced Password (Y) ? _
Disable Port 77F0h ? _
Configurable Pins on page 77.
6: Configuration via Serial Mode or Telnet Port
9600
4C (1 stop bit, no parity, 8 bit, RS-232C, no flow
control)
10001
C0 (always accept incoming connection; no active
connection startup)
3
250 (msec)
0x0D (CR)
0
74