Updating Or Deleting A Classification Rule Profile - Motorola PMP 320 Administration And Configuration Manual

PMP 320 Administration and Configuration Guide
3
4

Updating or deleting a Classification Rule Profile

Use the following procedure to update or delete classification profiles.
Procedure 7-4 Updating a classification profile
1
2
MAR 2010
Add a Classification Rule by entering the following information:
x Profile – profile identifier
x Rule – do not enter a rule ID unless there are multiple rules for a
given profile. Rules are not needed for normal operation.
x Type – select the type, IP TOS, IP Masked Source Address, IP
Masked Destination Address
x ToS – the interface accepts values as TOS (type of service) not
DSCP. The TOS value is a DSCP value multiplied by 4.
x IP Address – provide the IP address
x IP Mask Length – enter a value based on the network IP
configuration covering the cluster of IP addresses, for example, if
/24, it represents the classification applied for the 254 IP address
network. Or if /32 is used, the classification represents one single
IP address.
Do not enter the Rule ID unless you want to create multiple rules for a given profile,
rules are typically not needed on for normal operation.
Click Add to add the Classification profile.
Log in to the AP GUI; refer to the
Select Configuration > Service Flows > Classification Rules from the navigation
pane.
Setting up the CSM for AAA Authentication
Procedure 2-2 Logging in to the AP GUI
.
7-5