Arp Entry Configuration - NETGEAR GS752TP Software Administration Manual

ARP Entry Configuration

To add a static entry to the ARP table:

1. Select Routing
The following screen displays:
2. In the IP Address field, specify the IP address that you want to add.
It must be the IP address of a device on a subnet attached to one of the switch's existing
routing interfaces.
3. In the MAC Address field, specify the unicast MAC address of the device.
The format is six 2-digit hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.
4. Click ADD to add the static entry to the switch configuration.
To delete a static entry from the ARP cache, select DELETE.
Entries for the switch are displayed in the Routing VLANs ARP Cache Table. This table
contains both static and dynamic addresses. Static addresses are manually configured and
do not age out. The device creates dynamic addresses from the ARP packets it receives.
Dynamic addresses age out after a configured time
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
ARP > Advanced

Configuring Routing
ARP Create.

135