NETGEAR GS752TP Software Administration Manual page 117

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The following screen displays:
2. In the VLAN ID field, select the VLAN IDs for which MLD snooping is enabled.
3. In the Admin Mode field, enable MLD Snooping for the specified VLAN ID.
4. In the Fast Leave Admin Mode field, enable or disable the MLD Snooping Fast Leave
mode for the specified VLAN ID.
5. In the Group Membership Interval field, enter the value for the group membership interval
of MLD Snooping for the specified VLAN ID.
The value is calculated as the Multicast Router Expiry Time + ½ Maximum Response
Time.
6. In the Maximum Response Time field, set the value for maximum response time of MLD
snooping for the specified VLAN ID.
The valid range is 1–20 seconds.
7. In the Multicast Router Expiry Time field, enter the value for multicast router expiry time
of MLD snooping for the specified VLAN ID.
The valid range is 3 – 3610 seconds. This value is calculated as: 2 * QI + ½ Maximum
Response Time, where:
QI = (Group Membership Interval – Maximum Response Time) / 2
8. Click ADD to enable MLD Snooping on the specified VLAN.
9. Click APPLY to send the updated configuration to the switch.
Configuration changes take place immediately.
Configuring Switching Information
117