Setup Snmp Page - Mitsubishi Electric Netcom 2 User Manual

7.13 Setup SNMP Page

The Setup/SNMP NMS
that will be viewing the UPS information using GETs and SETs. The Get operation is
used by the NMS to obtain the necessary information and the SETs command are used to
configure the management device for the information. The network management stations
that must access the units SNMP function must be entered at this page. For each Network
Management Station the following must be entered.
 NMS IP Address- Enter the IP address for the NMS
 Community – Enter the SNMP community string the NMS will use. Contact your
system administrator for details
 NMS- The read only access permits the network management station to use only
GET commands. The Read/Write access permits the network management station
to use both GET and SET commands.
Note: A copy of the Netcom MIB files can be found on the Netcom CD, www.meppi.com,
or in Appendix B of this manual.
Rev 3 02/24/2009
Mitsubishi Netcom User Manual
Figure 15 Setup SNMP NMS
function is used to set up the network management station
19