Mitsubishi Electric Netcom 2 User Manual page 43

Mitsubishi Netcom User Manual
"The present true power conveyed by the bypass (watts)."
::= { upsBypassEntry 4 }
upsAlarm OBJECT IDENTIFIER ::= { MitsubishiUPS 6 }
upsAlarmsPresent OBJECT-TYPE
SYNTAX Gauge
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The present number of active alarm conditions."
::= { upsAlarm 1 }
upsAlarmTable OBJECT-TYPE
SYNTAX SEQUENCE OF UpsAlarmEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
"A list of alarm table entries.
an OBJECT IDENTIFIER, upsAlarmDescr, to allow a single
table to reflect well known alarms plus alarms defined
by a particular implementation, i.e., as documented in
the private enterprise MIB definition for the device.
No two rows will have the same value of upsAlarmDescr,
since alarms define conditions.
requirement, care should be taken in the definition of
alarm conditions to insure that a system cannot enter
the same condition multiple times simultaneously.
The number of rows in the table at any given time is
reflected by the value of upsAlarmsPresent."
::= { upsAlarm 2 }
upsAlarmEntry OBJECT-TYPE
SYNTAX UpsAlarmEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
"An entry containing information applicable to a
particular alarm."
INDEX { upsAlarmId }
::= { upsAlarmTable 1 }
UpsAlarmEntry ::=
SEQUENCE
{
upsAlarmId
upsAlarmDescr
upsAlarmTime
}
upsAlarmId OBJECT-TYPE
SYNTAX PositiveInteger
ACCESS read-only
STATUS mandatory
DESCRIPTION
"A unique identifier for an alarm condition.
Rev 3 02/24/2009
Alarms are named by
In order to meet this
PositiveInteger,
AutonomousType,
TimeStamp
41
This