Configuring The Remote Shutdown Agents From The Netcom; Netcom Forwarder; Installing And Configuring The Forwarder Agent; Configuring The Netcom To Send Shutdown Messages To The Forwarder Agent - Mitsubishi Electric Netcom 2 User Manual

Mitsubishi Netcom User Manual
6. Follow the installation prompts to install the software.
7. Following the completion of the installation, the files will be installed but the
service will need to be started.
Perform the following steps to configure and start the remote shutdown agent:
Starting and Configuring the Remote Agent Service:
1. Open a command terminal.
2. While logged in as root, run the following command: /etc/DevMan setup
3. The script will now ask you questions about configuring the software.
4. The setup will ask you to specify the IP address of the Netcom. Leave this
address blank if you want to allow any Netcom to manage the shutdown agent.
5. The DevMan script has other useful options. Rut it without the setup argument
to see the Usage line.
Perform the following steps to uninstall the remote shutdown agent:
1. Open a command terminal.
2. Go to the location where you unzipped the DiamondLinkRAX.X-OSX.tar.gz
file during the installation.
3. Go into the DiamondLinkRAX.X-OSX folder that was created.
4. Run the following command: ./Uninstall

8.2 Configuring the Remote Shutdown Agents from the Netcom

Select the Shutdown Setup
configure the Netcom to shut down remote computers.

9 Netcom Forwarder

The Netcom is limited to shutting down 24 remote computers. If there is a need to
shut down additional computers, you can use the Netcom Forwarder to do so. The
Netcom Forwarder is purchased as a separate software product. Contact Mitsubishi or
your Netcom vendor to purchase this software. The Netcom Forwarder will run on
Windows XP Professional, Windows 2000 or Windows 2003.

9.1 Installing and Configuring the Forwarder Agent

Perform the following steps to install the Forwarder Agent:
1. Insert the CD. The installation will start automatically. Reply to the standard
prompts.
2. Configure the forwarder to communicate with the Netcom. Enter the IP address
of the Netcom and check the Netcom box.

9.2 Configuring the Netcom to send shutdown messages to the Forwarder Agent

Perform the following steps to configure the Netcom to send alarms to the
Forwarder Agent:
1. Browse to the Netcom and select the Shutdown Setup menu option.
Rev 3 02/24/2009
menu option from the Netcom user interface to
30