Mitsubishi Electric Netcom 2 User Manual page 51

Mitsubishi Netcom User Manual
DESCRIPTION
"This object determines the nature of the action to be
taken at the time when the countdown of the
upsShutdownAfterDelay and upsRebootWithDuration
objects reaches zero.
Setting this object to output(1) indicates that
shutdown requests should cause only the output of the
UPS to turn off.
indicates that shutdown requests will cause the entire
UPS system to turn off."
::= { upsControl 1 }
upsShutdownAfterDelay OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Setting this object will shutdown (i.e., turn off)
either the UPS output or the UPS system (as determined
by the value of upsShutdownType at the time of
shutdown) after the indicated number of seconds, or
less if the UPS batteries become depleted. Setting
this object to 0 will cause the shutdown to occur
immediately.
countdown.
state at the time the countdown reaches 0, then
nothing will happen.
action at that time if upsShutdownType = system and
the system is already off.
additional action at that time if upsShutdownType =
output and the output is already off.
upsShutdownAfterDelay will return the number of
seconds remaining until shutdown, or -1 if no shutdown
countdown is in effect.
is restarted while a shutdown countdown is in effect,
the countdown may be aborted.
override any upsShutdownAfterDelay already in effect."
::= { upsControl 2 }
upsStartupAfterDelay OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Setting this object will start the output after the
indicated number of seconds, including starting the
UPS, if necessary.
cause the startup to occur immediately.
object to -1 will abort the countdown.
is already on at the time the countdown reaches 0,
then nothing will happen.
override the effect of any upsStartupAfterDelay
countdown or upsRebootWithDuration countdown in
progress.
the number of seconds until startup, or -1 if no
startup countdown is in effect.
Rev 3 02/24/2009
Setting this object to system(2)
-- UNITS seconds
Setting this object to -1 will abort the
If the system is already in the desired
That is, there is no additional
Similarly, there is no
On some systems, if the agent
-- UNITS seconds
Setting this object to 0 will
Sets to this object
When read, upsStartupAfterDelay will return
49
When read,
Sets to this object
Setting this
If the output
If the countdown