Login Page - Mitsubishi Electric Netcom 2 User Manual

7.1 Login Page
After connecting to the Netcom Figure 2 will be displayed, the default password
for the Netcom is:
The Netcom2 Firmware version is located under the Serial number; the most current
software version can be downloaded at Meppi.com.
The default password and login for the Netcom is admin, admin. If the password
is changed and lost the following steps will need to be completed to reset the password;
1. Establish a Hyper-terminal session as described in Section 4 of this manual.
2. Connect a terminal to the serial port.
3. Reboot the Netcom.
4. At the serial prompt enter "test" within 5s.
5. At the serial prompt enter "pwdrst".
6. At the serial prompt enter "x".
7. When the system starts (status indicator flashing at 4Hz) login using
"admin"/"admin"
8. Change and save system user configuration as needed.
9. Reboot
SVA026 Netcom 2 User Manual ver5
Figure 7
Username: admin
Password: admin
20