Mitsubishi Electric Netcom 2 User Manual page 50

Mitsubishi Netcom User Manual
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"No tests have been initiated and no test is in progress."
::= { upsWellKnownTests 1 }
upsTestAbortTestInProgress OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The test in progress is to be aborted / the test in
progress was aborted."
::= { upsWellKnownTests 2 }
upsTestGeneralSystemsTest OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The manufacturer's standard test of UPS device systems."
::= { upsWellKnownTests
upsTestQuickBatteryTest OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"A test that is sufficient to determine if the battery
needs replacement."
::= { upsWellKnownTests 4 }
upsTestDeepBatteryCalibration OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The system is placed on battery to a discharge level,
set by the manufacturer, sufficient to determine
battery replacement and battery run-time with a high
degree of confidence.
the battery in a low charge state and will require
time for recharging to a level sufficient to provide
normal battery duration for the protected load."
::= { upsWellKnownTests 5 }
upsControl OBJECT IDENTIFIER ::= { MitsubishiUPS 8 }
upsShutdownType OBJECT-TYPE
SYNTAX INTEGER
{
output(1),
system(2)
}
ACCESS read-write
STATUS mandatory
Rev 3 02/24/2009
3 }
WARNING: this test will leave
48