.................................................................................................................................................................................................................................

Overview

The WaveStar

• Direct LAN access (point-to-point)

NOTE: This is the only method of connecting before system parameters have been

set and before the network has been established.

• LAN access (network)

• Remote access via DCC

• Remote access via TCP/IP.

Direct LAN access (point-to-point)

The WaveStar

"CIT" port of the user panel or through a backplane connector (LAN I/O Panel). A

shielded CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4,

Figure 4-48, "CIT connection (LAN crossed)" (p.

connection.

NOTE: The crossing can also be realized by a C5XOVER adapter (female to female,

CC408357903). This adapter works inline with two CAT5 straight cables.

The following figure illustrates direct LAN access (point-to-point).

Figure 7-1 Direct LAN access (point-to-point)

Safety

Electronic components can be destroyed by electrostatic discharge.

Use a static ground wrist strap. Always observe the ESD instructions (cf.

discharge" (p.

365-374-187

Issue 1, December 2005

CIT to the NE

CIT can be connected to a network element in four different ways:

CIT (LAN card) is connected to the LambdaUnite

User Panel

PWR ON

NE ACTY

FE ACTY

ACO

CIT (LAN)

ABN

LED TEST

CAUTION

ESD hazard

1-20)).

Lucent Technologies - Proprietary

See notice on first page

MSS via the

4-74)) must be used for this

WaveStar CIT

"Electrostatic

7-3

Table of Contents

Chapters

Table of Contents

Connecting The Wavestar; Cit To The Ne; Ne Provisioning; Cit Connection (Lan Crossed) - Lucent Technologies LambdaUnite Installation Manual

NE provisioning