External Timing Inputs - Lucent Technologies LambdaUnite Installation Manual

NE provisioning

External timing inputs

.................................................................................................................................................................................................................................
Overview
This section provides a procedure for configuring the external timing inputs.
Required equipment
Prior to performing this task, the following equipment must be available:
1. WaveStar
2. CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4,
4-48, "CIT connection (LAN crossed)" (p.
Prerequisites
Prior to performing this task, you must have done the following:
1. Logged in to WaveStar
WaveStar
enabled during WaveStar
2. Logged in to the NE.
3. The external timing input ports must be connected to an external timing source.
Procedure
Complete the following steps to configure the external timing input ports:
.................................................................................................................................................................................................
In the WaveStar
1
Result:
External Input 1
.................................................................................................................................................................................................
Select the timing input format in the group box
2
the respective radio button. Select the format according to the format of the external
clock source.
The following values are possible for SDH:
•
2 MHz
•
2 Mbit - framed
•
2 Mbit - unframed
The following values are possible for SONET:
•
ESF
•
SF
.................................................................................................................................................................................................................................
7-34
®
CIT PC
®
®
CIT application" (p.
®
CIT
System View
The Synchronization Characteristics
. For port 2, select
(supports SSM)
(Extended Super Frame; supports SSM)
(Super Frame)
Lucent Technologies - Proprietary
See notice on first page
4-74))
CIT as Super User (see chapter 5, section
5-18)) if WaveStar
®
CIT installation.
Configuration → Timing/Sync
, select
External Input 2
Input Signal Format
"Starting the
®
CIT User Login has been
window appears with the active tab
.
by clicking on
Issue 1, December 2005
Figure
.
365-374-187