Advertisement
STEP 1 - Connect the power
Make sure that the cradle is powered with a 6V DC adapter and that the
The
blue
Bluetooth LED will start to flash indicating that there is no active Bluetooth connection.
STEP 2 - Configure the scanner.
Before one or more configuration barcodes can be scanned, the 'Start config' barcode has to be
scanned. When done with the configuration, the 'End config' barcode has to be scanned.
_ZZ_
Start
Set the OPI-3301 to default Bluetooth SPP. (This is the communication standard between
scanner and cradle; it does not define the communication standard between cradle and PC)
_SO_
Default Bluetooth SPP
STEP 3 - Select and configure the interface Cradle - PC.
First select the physical interface (RS232 or USB). When RS232 is used, leave the USB port
unconnected, and then no configurations are required. For USB, you can make a choice between
USB-HID and USB-VCP. For USB-VCP there are two options: with handshaking/retries, and
without handshaking. The no handshake option is faster but less secure.
_CNC2_
USB-HID
STEP 4 - Make a Bluetooth connection between the scanner and the cradle.
Scan the Bluetooth address label on the bottom of the CRD-3301 cradle. The scanner will then
pair with the cradle and connect with it. Once the connection is established, the blue LED on the
cradle will light up continuously. Once the scanner is paired to the cradle the following barcodes
can be used to disconnect resp. connect the scanner to the cradle.
(Note that these are not configuration barcodes so it is not needed to scan the Start/End barcode)
_+-DISC-+_
Manual Disconnect
For more information about the CRD-3301, downloads and more, visit us at:
www.opticonusa.com/start
www.opticon.com/service-and-support.aspx
_ZZ_
End
_CNPC_
USB-VCP (No Handshake)
or
CRD-3301-QUICK START GUIDE
red
_CNCR_
USB-VCP (Handshake and retries)
_+-CONN-+_
Manual Connect
power LED lights up.
Advertisement
