Installing The Rack Rails; Installation In Racks With Round Or Square Holes - HP StorageWorks Reference Manual

Rack Installation

Installing the rack rails

Installation procedures vary depending on the rack type. The rails are shipped
ready for installation in racks with round or square holes. If the rails are to be
installed in racks with 10-32 threaded holes, the mounting pins must first be
removed. Refer to one of the following sections for installation instructions for
your rack.

Installation in racks with round or square holes

Note:
1. Insert the pins in front mounting plate of the outer rack rails into the
Figure 7: Installing the rack rails in front of rack
Note:
outside of the rack rail and slide it forward
18
"Installation in racks with round or square
"Installation in racks with 10-32 threaded
The ends of the rack rails are marked FRONT and REAR for proper orientation.
previously marked holes in the front vertical mounting bars of the rack. See
Figure 8. The rack rails will lock securely into place.
2
To remove the rail for repositioning, push the spring-loaded tab
holes" on page 18
holes" on page 20
1
F R
O N
T
1
4
3
.
4
1U Rackmount Tape Enclosure Reference Guide
1
15116
on the
3