Installing the enclosure into the rack
To install the enclosure into a rack:
1.
Secure the front end of the rails to the rack.
IMPORTANT:
Do not remove the pins from the ends of the rack rails unless you are converting the rails for use
in round-hole racks. These load-bearing pins are designed to fit through the holes without being
removed.
IMPORTANT:
Be sure that the scissor-type locking latches engage the rack fully when the pins extend through
the holes marked with the template.
NOTE:
Identify the left (L) and right (R) rack rails by markings stamped into the sheet metal.
2.
Secure the back end of the rails to the rack.
IMPORTANT:
Be sure that the scissor-type locking latches engage the rack fully when the pins extend through
the holes marked with the template.
18
Installing the enclosure