Completing The Installation - HP StorageWorks Reference Manual

Rack Installation

Completing the installation

1. Extend the stabilizing feet if provided on your rack.
2. Extend the left and right rack rails from the front of the rack.
3. Align the rear of the component rails on the tape enclosure with the front ends
Figure 12: Slide 1U tape enclosure into rack
Note:
the unit. Press the latches on each side
Figure 12
4. Tighten the front panel thumbscrews.
5. If used, retract the stabilizing feet of the rack.
22
of the rack rails, then slide the unit fully into the rack. See
4
3
1
F R
O N
T
Caution: Be sure to keep the enclosure parallel to the floor when sliding the
component rails into the rack rails. Tilting the enclosure up or down could
damage the rails.
To remove the enclosure from the rack, disconnect the cables from the back of
for the location of the latches.
2
15111
and pull the enclosure from the rack
3
1U Rackmount Tape Enclosure Reference Guide
Figure 12.
. See
4