Roland CAMM JET CJ-70 User Manual page 29

8
Without moving the cutting carriage, remove the
alignment tool and attach the blade holder.
2 HEAD ADJUST
Mechanical deviation caused by temperature is corrected, and the correction value stored to the CJ-70/60. If the ambient temperature
variation is low, this correction setting should not have to be changed. The setting will not be erased even if the power is turned off.
1
Load the material and
press the
2
Press the
the following screen appear on the display.
3
Press the
screen appear on the display.
5
Install the alignment tool on the cutting carriage.
6
Use the arrow keys to move the tip
of the alignment tool to the square
crop mark at the lower right area of
the material.
The SETUP LED
lights up
key.
key and key to make
MENU
HEAD ADJUST
key to make the following
HEAD ADJUST
TEST PRINT
9
Press the key to
start cutting.
4
Use the key to select "PRINT-CUT ADJ"
then press the
HEAD ADJUST
PRINT - CUT ADJ
Crop mark is printed.
Rear
Front
key.
Rear
Front
Crop mark
Set here, and press
key.
27