To Perform Long Printing/Cutting - Roland Color CAMM PC-50 User Manual

6 To Perform Long Printing/Cutting

6 To Perform Long Printing/Cutting
When performing printing or cutting over a length of 1.5 m (60") or more, first feed out the required length of material. Then
follow the steps below to load the material.
4
3
25 mm
(1")
or more
Material
alignment
stickers
5
Press the SETUP
key.
14
1
Pull out the material from the roll and
pass it through the unit.
Use material that is wider by 50 mm (2") or more than
the width of the printing or cutting to be performed.
6
Feed out the length
of material to be
printed or cut.
Make sure that the material
remains held by the pinch
rollers.
If the material does come
loose from the pinch rollers,
set it in place again.
Pull out the amount of
roll material to be used.
Guide line
2
25 mm
(1")
or more
Guide line
7
Return the fed-out
material.
8
After finishing the
setup for the material,
send the data from
the computer.
Material
alignment
stickers